Preparation, characterization and in vitro release of berberine hydrochloride resin complex / 药学学报

The object of this study is to preparate the berberine hydrochloride (BBH) resin compound with taste masking effect. We took the BBH as the model drug and Amberlite IRP69 as the drug carriers, uncovered the curve of solubility of BBH in different cosolvent with a certain range of temperature, and then used it to calculate the parameters during the preparation of the complex such as adding quantity of BBH and the reaction temperature. Afterwards, the characteristic and in vitro release experiments were studied to verify the formation and predict the in vivo release behavior of the complex. The results showed that in the condition of using 60% ethanol as a cosolvent and stirring at 50 ℃ for 1 h, the drug loading and drug availability of the complex are at about 35% and 64%, respectively, and has a better taste-masking effect. In this study, a method was provided for preparing a taste-masking preparation of BBH.

Quality characterization of radix paeoniae alba in huangqi guizhi wuwu decoction / 国际药学研究杂志

Objective: To establish the HPLC fingerprint of the chemical components of the decoction of Radix Paeoniae Alba(RPA)and determine the content of paeoniflorin, so as to provide a scientific method for the quality char- acterization and control of RPA and establish a correlation between the quality of standard granules in classical prescrip- tion and the quality of RPA. Methods: Thermo Syncronis C18(250 mm×4.6 mm, 5 μm)chromatographic column was used, the mobile phase was constituted by acetonitrile(A)and 0.05 % phosphate aqueous solution(B), the detection wavelength was 230 nm, the column temperature was 30℃, the flow rate was 1.0 ml/min, and the injection volume was 20 μl;the gradient eluting procedure was 0-15 min, 5% A-15% A;15-45 min, 15% A-25% A;45-65 min, 25% A-50% A. Results: The HPLC fingerprint of RPA was established, 11 common peaks were identified by HPLC-Q-TOFMS/ MS, and the similarity of 10 batches were evaluated. The content determination of paeoniflorin in 10 batches of RPA decoction-lyophilized powders was also completed. Conclusion: This study provides a scientific and reliable method for the quality characterization and control of RPA as well as a reference for the quality characterization and control of the standard decoction and granules.

Research Progress and Forensic Identification of Alcoholic Cardiomyopathy / 法医学杂志

With the rapid development of the social economy in China, the incidence of diseases caused by excessive drinking is gradually increasing as well. Alcoholic cardiomyopathy refers to long-term high intake of ethanol, and has typical dilated cardiomyopathy characteristics, such as, hemodynamic changes, symptoms, signs, and morphological features. It is a kind of cardiomyopathy that excludes other causes of dilated cardiomyopathy. Due to the lack of specific pathological changes, the forensic pathological identification of alcoholic cardiomyopathy can only be based on the patient's medical history and by ruling out other causes of cardiomyopathy. This paper reviews the pathogenesis and forensic identification of alcoholic cardiomyopathy in order to provide reference for forensic pathologists and clinicians.

Three-dimensional finite element analysis on stress distribution after greater trochanter bone flap for treating osteonecrosis of the femoral head / 中国组织工程研究

BACKGROUND: Three-dimensional finite element analysis has been used by many scholars from department of orthopedics, but the results of postoperative evaluation of hip preserving treatment for osteonecrosis of femoral head are different. OBJECTIVE: To study the biomechanical changes of the femoral head and the biomechanical changes of the proximal femur after greater trochanter bone flap for the treatment of femoral head necrosis using three-dimensional finite element method, and to verify the mechanical safety and effectiveness. METHODS: One case of unilateral femoral head necrosis in ARCOIII stage undergoing parallel vascularized greater trochanter bone flap transplantation was selected. Computed Tomography data of proximal femur were collected before and 6 months after the operation, and preserved in DICOM format. With the aid of computer technology, professional medical modeling software, MIMICS and HYPERMESH, were used to establish the three-dimensional geometric models of the proximal femur. These models were divided into normal group, necrosis group and repair group. Finite element analysis software ANSYS was utilized to simulate human body standing and movement in different situations. The model was divided by free mesh, and given material parameters to establish normal proximal femur, femoral head necrosis and bone defect. Greater trochanter bone flap was applied in repairing three-dimensional finite element model of bone defect. Loads were loaded on different finite element models. The maximum displacement of the femoral head and the stress distribution in the proximal femur of the three groups were observed under different loading models. RESULTS AND CONCLUSION: (1) Under the same load, the maximum displacement of the three sets of models was 0.61 mm in the normal group, 0.66 mm in the necrosis group, and 0.61 mm in the repair group, respectively. Maximum Von Mises stress was greater in necrosis model than in the normal molding. The maximum Von Mises stress gradually decreased in the repair model, and was close to normal value. (2) Three groups of models showed stress concentration above the rotor in femoral neck region. The maximum stress in the trochanteric position was higher in necrosis models than in normal models. The maximum stress in this region gradually increased after repair, but was still lower than the failure stress of bone. (3) The results confirm that the maximum stress and the maximum displacement are closer to the normal value after greater trochanter bone flap for treatment of osteonecrosis of the femoral head. The greater trochanter is safe and reliable for repairing bone defect of femoral head.

CT angiography-based simulation of the surgical approach in early operation for ruptured aneurysm / 南方医科大学学报

<p><b>OBJECTIVE</b>To simulate the surgical approaches for intracranial aneurysms using three-dimensional CT angiography (3D-CTA) and assess the value of 3D-CTA in early microneurosurgery for ruptured intracranial aneurysms.</p><p><b>METHODS</b>Forty-eight patients with spontaneous subarachnoid hemorrhage due to ruptured intracranial aneurysm were confirmed by early operation. All the patients were classified according to Hunt-Hess, including 11 of grade I, 29 of grade II, and 8 of grade III. CTA was performed before the operation and surgical simulation was conducted. The preoperative findings on CTA and the intraoperative findings were compared and the clinical value of cerebral 3D-CTA was analyzed.</p><p><b>RESULTS</b>Pre-operative 3D-CTA clearly displayed the location, size and shape of the aneurysms, the axis direction of the aneurysm apex and the width of aneurysm neck. The spatial relation between the parent aneutysm artery, the aneurysm, the peripheral vessels and the bony structures were also demonstrated. These findings were basically consistent with the intraoperative findings. The Glasgow outcome score was 5 in 41 patients, 4 in 4 patients, 3 in 2 patients, and 2 in 1 patient upon discharge from the hospital.</p><p><b>CONCLUSIONS</b>Preoperative 3D-CTA examination can simulate the surgery for ruptured aneurysms to help improve the surgical success rate.</p>

Ultrastructural analysis of glioma stem cells-progenitors / 中华肿瘤杂志

<p><b>OBJECTIVE</b>It is well known that glioma stem cells-progenitors (GSCP) proliferate indefinitely and hardly differentiate in vitro, however, the reasons remain unknown. The aim of this study was to explore the ultrastructural basis of GSCP.</p><p><b>METHODS</b>GSCP, kept by our laboratory, were collected, embedded, and cut into ultrathin sections and observed under the transmission electron microscope.</p><p><b>RESULTS</b>A single GSCP usually had relatively well developed mitochondria, Golgi apparatuses, ribosomes, and undeveloped rough endoplasmic reticulum, but seldom lysosomes and no typical autophagosomes were found, and the nuclear-cytoplasmic ratio was high. The nuclei frequently contained huge amounts of euchromatin and a small quantity of heterochromatin, and in most nuclei there were only one nucleolus, however, two or more nucleoli were also common. Typical apoptotic cells could hardly be found in tumor-spheres, and between neighboring cells in tumor-spheres there were incompletely developed desmosomes or intermediate junction.</p><p><b>CONCLUSION</b>The ultrastructural features of glioma stem cells-progenitors showed that BTSCP were very primitive and the lack of autophagy and the underdevelopment of some other cellular organelles are probably the reasons for the differential inhibition of GSCPs.</p>

Endoscopic surgery for hypertensive cerebral hemorrhage / 中南大学学报(医学版)

OBJECTIVE@#To evaluate the use of endoscopic surgery for hypertensive cerebral hemorrhage.@*METHODS@#Sixteen patients with hyertensive intracerebral hematoma were evacuated with neuroendoscope. The surgical invasive markers, volume of remaining hematoma, and prognosis were compared with those of 19 comparable patients undergoing conventional craniotomy.@*RESULTS@#Complete evacuation of hematoma was achieved in 9 patients, and partial evacuation in 7. All patients were followed up for 6 months. According to GOS, the result was excellent in 6 patients, good in 6, fare in 2, poor and dead in one respectively. The volume of remaining hematoa and invasive markers significantly decreased (P 0.05).@*CONCLUSION@#Neuroendoscopic surgery for hypertensive intracerebral hematoma is characterized by mini-invasion, time-saving, and direct-vision, and is a new approach in this field.